Tag Archives: metal cutting blades

Metal Cutting Circular Saw Blades: Six Quick Tips for Longer Blade Life

The initial cost of a metal cutting circular saw blade is more expensive than wood cutting blades. The good news is there are simple tips that will extend your blade life and lower the overall cost-per-cut. The Morse Metal Devil® metal cutting circular saw blade can cut through solid steel plate (6” x ¼”) in less than 12 seconds. If that kind of time savings and productivity is something you can use on your next project, keep reading!

 

1)Metal Devil® metal cutting circular saw blades are engineered to use dry cut technology.  That means you do not need to use lubricant or coolant with the Metal Devil blades.

2)These blades perform best when used with low RPM metal cutting saws, such as the Morse Metal Devil 7, 9 and 14-inch saws.

3)Select the correct blade design for your application to achieve the best performance, such as steel, thin steel, or aluminum blade.

4)Clamp your material securely so that it does not vibrate or spin. Morse offers a V-block clamp for tubes.

5)Extend the blade completely out of the saw and use a guide or straight edge to make the cut.

6)Bring the blade to full speed before entering the cut and do not push the saw through the material. Slow down and let the teeth make the cut.

 

Consistently follow these steps to optimize your blade life.

Happy Sawing –

h/t Steve Whaley, Technical Support @ M. K. Morse

 

From the Front Lines of Metal Cutting

Just a few weeks ago an Air Force Base was preparing planes for destruction.  They were looking for a 9″ (229mm) angle grinder to remove depleted uranium counterweights from some transport planes in preparation for sending them to the scrap yard.  The current grinder did not have sufficient depth to cut out a 3″ (76mm) deep aluminum support bracket.  When our sales rep showed up with a 9″ M.K. Morse Metal Devil Saw he was met by a skeptical group of technicians.  They graciously allowed him to give it a try.  After 20 minutes of getting into full PPE gear (Tyvek suit, respirator, gloves, and fall protections) and being lifted 50 feet into the air, he was ready to cut.  With the right saw for the job, the cut took a lot less time than getting into the gear.  Record time as a matter of fact!

jpegShop for MK Morse Circular Saws and Metal Devil Blades

Metal Devil End User and Application Guide pdf.